Online Drywall Anchor #8 x 1-1/4″ Self-Drilling with Screws Simpson Strong -Tie Hollow Wall Anchor Plastic 100 and 200#6 x 1″ Free/Bonus Inside

Shipping – Handling 1-2 Days Transit 2-3 Days – 1 Pack – Self Drilling Drywall Anchors with Screws Plastic Sure Wall Self Tapping Screws Simpson Strong Tie – SWN08LKT #8 x 1-1/4″ 100 Pieces All Together 1 Pack – Self Drilling Drywall Anchors with Screws Plastic Sure Wall Self Tapping Screws Simpson Strong Tie – SWN06KT #6 x 1″ 200 Pieces All Together Simpson Strong-Tie Sure Wall anchors are designed to self-drill into drywall and provide excellent holding value and greater capacity than screws alone. The standard Sure Wall cuts threads into drywall, greatly increasing the bearing surface and strength of the fastening. Features: Self-Drilling – Only a screwdriver needed for installation in gypsum board drywall Standard Sure Wall can be used as a fastener in fixtures with sufficiently large holes Includes screws with the anchors MATERIAL: Reinforced nylon Standard Sure Wall Installation Sequence (Nylon or Zinc) Sure Wall Gripper Installation Sequence Sure Wall Nylon Toggle Installation Sequence Drill a hole using the specified diameter carbide bit into the base material to a depth of at least 13 mm deeper than the required embedment. Blow the hole clean of dust and debris using compressed air. Overhead application need not be blown clean. Where a fixture is used, drive the anchor through the fixture into the hole until the head sits flush against the fixture. Be sure the anchor is driven to the required embedment depth. The Rod Coupler and Tie-Wire models should be driven in until the head is seated against the surface of the base material.